Molds are everywhere under the sun and elsewhere; inside and outside your homes. You do not need to join molds to lick them but you make use of mold removal tips.
1. To eliminate pesky mold; be wary of early warning sign of a moisture problem along your walls or ceilings that appears just a small dot at the beginning but turns into a colony within a few days. Even a tiny dot can be an enormous problem in the future. You cannot just wipe molds away; stop the water source.
2. Inspect drainage regularly; especially check pipes for leaks. You will never be sure if there are furry growth inside your ice maker lines or clinging to your plumbing fixtures, or crouching beneath water lines & pipes. Like humans, they want to survive by feeding off from water leaks. Water travels in all direction, so expect molds to molds to congregate near water leak.
3. Make a close inspection of all areas especially where wood in window wells, decks, vents and lashing on roofs is rotting. Be sure that any ground that is sloping and downspouts are away from the walls. If house is surrounded by wet and moisture ground, it is like a wick to the foundation or slab that will be supplying persistent dampness.
4. Outside leaks are likely to occur in vents, flashing and window wells. Fungal growth flourishes on exterior wall or ceiling. Look for a water leak on the wall even on your roof. Measuring distance from the moldy area using the door as reference point; then find the spot on the other side of the wall or ceiling.
5. Check rood for leaks or ductwork that is badly insulated. The moist and warm air condensing and forming on ducts are likely to carry cold air passing thru crawl space and/or the attic. A duct that is not insulated or there is a block in the vapor can be determined by sign of condensation. In this condition, insulation will be saturated with water including the drywall that could be a good place for mold spores to inhabit. But in cold weather, the reverse takes place. Moisture will be forming anywhere when warm air escapes at joint duct sections which are unsealed.
6. Most molds appear as dust as they are tiny and sometimes largely hidden on dirty areas. You can buy test kits to determine if the present dirt is mildew or mold and even the toxic black mold.
7. Spray the wall with an antimicrobial treatment to eliminate molds from growing around the tub or shower. Seal any possible openings using two coats of sealant to keep off water or any kind of moisture.
8. Get rid of minute fungal on a particular area and make sure that they will not return. Clean and dry entirely; afterwards, you can spray with antimicrobial spray solution to keep off furry growth from recurring.
If all efforts are saturated in eliminating household molds and still they recur after sometime then you have to consult a professional Mold Remover Company that you will assured that you will never see molds again in your home.